fiberglass self-adhesive tape

fiberglass mesh is widely used in wall reinforcement, out-side wall heat insulation, roofing waterproof.

Performance as follows:1.good performance of alkaline-resistance2.high tensile strength and deformation-resistance3.excellent self-adhesive performance4.simple and easy to be applied

ApplicationRepair the crack and joints or holes of drywall, plasterboard, stucco; and repair other damages in other wall surface.

Specifications:

1) Mesh size: 2.85 x 2.85mm (9 x 9 mesh), 3.2 x 3.2mm (8 x 8 mesh)

2) Weave: leno

3) Width: 50mm, 100mm, 150mm, 200mm, 1000mm, 1200mm, 1500mm, etc.

4) Length of roll: 20 m to 900m, Any demand length is available, or according to client requirements

5) Colors available: white , yellow, grey, silver , blue, black, etc.

6) Main size: 50mm x 90m, 50mm x 45m, 50mm x 20m, 50mm x 153m

7) packing: Inner packing: shrink packing or plastic bag,

Outer packing: 24 rolls or 54 rolls or 72 rolls/carton or pallet packing

Direction of Applications:1.Wall must be clean and dry2.Center and apply tape over the length of the joint, pressing firmly3.Apply a generous first coat of compound over the and through the mesh, making sure to completely fill the joint crevice. When the joint has been completely filled, wipe off any excess compound with the drywall knife leaving enough to cover the tape.4. Let dry completely, then sand slightly.5. Apply sufficient thin finishing coats to produce a smooth wall surface.6. Cut or butted boards do not have a tapered edge. Therefore, special care must be taken to assure proper compound penetration of all joints. This may result in slight build-up of compound that will require an increased amount of edge feathering.

Caution1.Failure to completely fill the joint may result in cracking.2. For best results, use a setting-type compound.

fiberglass self-adhesive tape